「技術は王道だ。」と言われました、IT技術をはじめ、ますます流行っています。Cisco CCDE認証の取得は自分のレベルを証明うえに、就職のチャンスがもっと多いです。Brain Dumps Cramは認定資格を取得の重要な問題集と思います。352-001試験の対応資格はCisco CCDEです。下記はCisco CCDE資格概要、ご参照ください。
Testpassport問題集はIT技術者向け設計の試験対策で、もっとも正確な問題と答えを含んでいる。Testpassportの352-001（ADVDESIGN）問題と答えを暗記しただけで、試験をパスしなければなりません。
どうしてTestpassport問題集はそんなに自信があるの？
一、testpassportの問題集は試験センターによって、よく更新します。だから、お客様が持っている問題集は最新版であることを保証できます。弊社のサイトはバージョン番号があります。もし、サイトのバージョン番号が変更すれば、弊社と連絡して、最新版問題集を送ります。
二、testpassport問題集は単項の選択問題、多肢選択問題、ドラッグ＆ドロップ、実験問題及び穴埋め問題 などの様々な試験項目を提供します。
三、Testpassportの web認定問題集はpdfとソフト版を提供して、pdf形式はプリントだけでなく、いくつのパソコンで使うことができます。ソフト版は実際の試験雰囲気を模擬したものです。
四、無料デモで試しに自信を持って認定合格になります。以下はTestpassportの352-001無料デモです
http://pdf.testpassport.jp/352-001.pdf
1.Lafeyette Productions is looking for a new ISP that has improved availability, load balancing, and
catastrophe protection. Which type of ISP connectivity solution would be best?
A.single run
B.multi-homed
C.stub domain EBGP
D.direct BGP peering
Answer:B
2.NetFlow provides valuable information about network users and applications, peak usage times, and
traffic routing. Which function is of NetFlow?
A.monitor configuration changes
B.monitor CPU utilization
C.monitor link utilization
D.generate traps for failure conditions
Answer:C
3.The company is deploying OSPF on a point-to-multipoint Frame Relay network. The remote sites
needn??t to communicate with each other and there are a relatively small number of sites (scaling is not a
concern). How to configure OSPF for this topology in order to minimize the additional routing information
injected into the network and keep the configuration size and complexity to a minimum?
A.Configure the link as OSPF nonbroadcast and manually configure each of the remote sites as a
neighbor.
B.Configure the link as OSPF broadcast and configure the hub router to always be the designated router.
C.Configure the link as OSPF broadcast and configure a mesh group towards the remote routers.
D.Configure the link at the hub router as OSPF point-to-multipoint and at the remote routers as OSPF
point-to-point.
Answer:B
4.What is high availability?
A.redundant infrastructure
B.clustering of computer systems
C.reduced MTBF
D.continuous operation of computing systems
Answer:D
5.What is the way that an OSPF ABR uses to prevent summary route information from being readvertised
from an area into the network core (Area 0)?
A.It advertises only inter-area summaries to the backbone.
B.It uses poison reverse and split horizon.
C.It only sends locally originated summaries to the backbone.
D.It compares the area number on the summary LSA to the local area.
Answer:C
現代においては、IT技術者として皆に羨まされます。IT技術者にとって、Cisco認証の取得するほど楽しいことはない。Cisco CCENT認証の取得はどんな重要なことか！Cisco CCENT資格を取得したかったら、問題集の使用は不可欠と思います。Cisco CCENT資格の対応試験は640-822です。
具体なCisco CCENT認証情報、下記のフォームご参照ください。
testpassport問題集は最新の640-822（Interconnecting Cisco Networking Devices Part 1）問題集を含んで、100％試験合格率を保証されてます。Testpassport問題集はIT専門家グループによって作り上げられて、英語が世界で普通の言語ので、多くのシミュレーション問題の対策は英語版です。
testpassport問題集はいろいろな試験タイプを提供します。例えば、ドラッグ＆ドロップ、実験問題、多肢選択問題、単項の選択問題及び穴埋め問題など。理解やすいので、初心者としても10～20時間の独学だけで、一発合格が可能です。
testpassport認定試験の問題と答えを暗記しただけで、Cisco CCENT認定資格の取得はそんな簡単ものです。この科目は222問です。（御客様のために、弊社は見積書及び領収書(PDF版)を提供できます。）
testpassporの640-822模擬問題集の無料デモを見れば、こちらをクリックしてください。
1. Refer to the exhibit. A network technician has added host A to the network. Host A cannot communicate
on the network. A ping that is issued on the host to address 127.0.0.1 fails. What is the problem?
A. The router is not forwarding the ping packets to network 127.0.0.0.
B. The remote host at 127.0.0.1 is unreachable.
C. The default gateway is incorrect.
D. The IP address of host A is incorrect.
E. The TCP/IP protocols are not loaded.
Answer: E
2. Refer to the exhibit. A network technician is attempting to use HyperTerminal to configure a new router
using the settings shown. What is the reason the technician is unable to connect to the router?
A. The bits per second should be set to 9600.
B. The data bits should be set to 6.
C. Parity should be set to mark.
D. The stop bits should be set to 2.
E. Flow control should be set to hardware.
Answer: A
3. Refer to the exhibit. What could be possible causes for the “Serial0/0 is down” interface status?
(Choose two.)
A. A Layer 1 problem exists.
B. The bandwidth is set too low.
C. A protocol mismatch exists.
D. An incorrect cable is being used.
E. There is an incorrect IP address on the Serial 0/0 interface.
Answer: AD
4. Which line from the output of the show ip interface command indicates that there is a Layer 1 problem?
A. Serial0/1 is up, line protocol is up
B. Serial0/1 is up, line protocol is down
C. Serial0/1 is down, line protocol is down
D. Serial0/1 is administratively down, line protocol is down
Answer: C
初心者はどのようにCCNP認定資格を取得しますか？CCNP認定資格の対応試験は642-813です。642-813(Implementing Cisco IP Switched Networks)試験を通した後、642-813受験者は自身のレベルを証明することができます。
ITエリートのCCNP認定資格取得ために正確な認定準備資料を提供します。Testpassport 642-813受験参考書を提供して、気楽100％合格することができます。弊社の問題集を利用して、CCNP認定資格取得のは夢ではありません、そして、独学可能です。会社であれば、インタ-ネットの領域であれば、自己のレベルを証明するために、CCNP認定証を持った無ければなりません。
無料サンプルを提供して、買う前に、642-813無料デモを見られます。
http://pdf.testpassport.jp/642-813.pdf
1.Company uses layer 3 switches in the Core of their network. Which method of Layer 3 switching
uses a forwarding information base (FIB)?
A. Topology-based switching
B. Demand-based switching
C. Route caching
D. Flow-based switching
E. None of the other alternatives apply
Answer: A
2.You need to design the VLAN scheme for the Company network. Which two statements are true
about best practices in VLAN design? (Select two)
A. Routing should occur at the access layer ifvoice VLANs are utilized. Otherwise, routing should
occur at the distribution layer.
B. Routing should always be performed at the distribution layer.
C. VLANs should be localized to a switch.
D. VLANs should be localized to a single switch unlessvoice VLANs are being utilized.
E. Routing should not be performed between VLANs located on separate switches.
Answer: B,C
3.Refer to the exhibit. On the basis of the information provided in the exhibit, which two sets of
procedures are best practices for Layer 2 and 3 failover alignment? (Choose two.)
A. Configure the D-SW1 switch as the active HSRP router and the STP root for all VLANs.
Configure the D-SW2 switch as the standby HSRP router and backup STP root for all VLANs.
B. Configure the D-SW1 switch as the standby HSRP router and the STP root for VLANs 11 and
110. Configure the D-SW2 switch as the standby HSRP router and the STP root for VLANs 12 and
120.
C. Configure the D-SW1 switch as the active HSRP router and the STP root for VLANs 11 and
110. Configure the D-SW2 switch as the active HSRP router and the STP root for VLANs 12 and
120.
D. Configure the D-SW2 switch as the active HSRP router and the STP root for all VLANs.
Configure the D-SW1 switch as the standby HSRP router and backup STP root for all VLANs.
E. Configure the D-SW1 switch as the active HSRP router and the backup STP root for VLANs 11
and 110. Configure the D-SW2 switch as the active HSRP router and the backup STP root for
VLANs 12 and 120.
F. Configure the D-SW1 switch as the standby HSRP router and the backup STP root for VLANs
12a nd 120. Configure the D-SW2 switch as the standby HSRP router and the backup STP root
for VLANs 11 and 110.
Answer: C,F
4.If you needed to transport traffic coming from multiple VLANs (connected between switches), and
your CTO was insistent on using an open standard, which protocol would you use?
A. 802.11B
B. spanning-tree
C. 802.1Q
D. ISL
E. VTP
F. Q.921
Answer: C
5.Under what circumstances should an administrator prefer local VLANs over end-to-end VLANs?
A. Eighty percent of traffic on the network is destined for Internet sites.
B. There are common sets of traffic filtering requirements for workgroups located in multiple
buildings.
C. Eighty percent of a workgroup’s traffic is to the workgroup’s own local server.
D. Users are grouped into VLANs independent of physical location.
E. None of the other alternatives apply
Answer: A
